There are many details that should be paid attention to during the application of rubber rollers, which are briefly described as follows:
1. When turning on the heating, check whether the silicone roller rotates normally. When turning off, set the residual temperature delay too fine to see if it is normal. It is not possible to turn off directly (the residual temperature delay is usually set at 40-50 minutes);
2. In the process of dullness, if there is a sudden shutdown due to power failure, or other reasons, you should immediately wear gloves and remove the rubber roller while rotating it and put it in another place to dissipate heat, so as to avoid uneven heat from burning the silicone. 
3. When changing the rubber roller to tighten the silica gel, wait until the silica gel is heated to the required temperature before locking firmly, but not too tight;
4.The silicone roller should be kept clean, even if the transfer film debris is prevented from sticking to the rubber roller's appearance, if the appearance has dirt, it can be cleaned with cloth processing alcohol. If there is stubborn dirt, sand it with fine sandpaper.
5. Like other printing rubber rollers, silicone rollers should not collide with other hard objects (such as wrenches) or squeeze them when they are used or stored. Stay away from corrupted items;
6. The temperature of the silica gel can be transferred normally at about 190 degrees. In the environment where the product transfer is qualified, the pressure and temperature of the silica gel roller should be reduced.