How to use?

1. Turn on the power, turn on the power switch, press and hold the start button for 3-5 seconds, the computer screen will light up, that is, the boot is successful.
2. Install the special silicone wheel for heat transfer machine at the position of the silicone wheel, then turn on the heating switch, and observe whether the silicone wheel rotates clockwise.
3. Adjust the thermostat to the required temperature, generally around 180 degrees Celsius, and start working 15 minutes after the temperature reaches the set temperature.
4. While heating, install the product fixture on the work surface.
5. Put the thermal transfer film into the machine, adjust the position of the light spot, and make the thermal transfer film, the substrate and the silica gel in the appropriate corresponding positions. Note: Do not exceed the thermal transfer film with silicone, otherwise it may cause the substrate to be deformed and burnt.
6. Press the job key to start the film test and adjust the printing time.
7. When the time of the time controller for instructing hot stamping is up, the machine head is up, that is, the printing is completed. Precautions:
1. Pressure: If the pressure is not enough or too large, adjust the pressure regulating knob of the machine head to increase the pressure in a clockwise direction; otherwise, reduce the pressure;
2. Time: When the hot stamping time arrives and the buzzer does not ring or keeps ringing, if it is not comfortable, it must be adjusted to an appropriate position;
3. Temperature: When the adjusted temperature is reached, the pointer of the thermostat points to the "180°C" position (about 5 minutes to arrive). If the thermometer rises and the heating plate does not heat up, please check the circuit.